Delta patented a design for the band saw that included the slot for entering the blade to run to the side of the table. The Delta Band Saw has changed very little over the years. 28-205 included the same saw on a cast iron stand. It included the open steel stand as shown. 28-207 provided the complete 14" Woodworking Band Saw as shown in the photos on the right and left. So Delta decided upon a standard machine that cuts up to 6" thick and they offer an attachment that will increase the capacity to 12". Similarly, since over 90% of all band-saw work is done on stock less than 6" thick, to provide greater capacity than this is merely to penalize the user who does not require it. In the comparatively few cases where the "swing" of the work required a larger throat capacity, it was found that a band saw of 20" to 24" swing was required, and the the addition of one or two inches to the throat was of no practical value. Why a Delta Band Saw 14" is the Most Practical Medium-Size Machineĭelta researched and discovered that since over 90% of all band-saw work is done outside of the table, on the side away from the frame, the 14" capacity is fully as effective as that of any other band saw, no matter how large. Delta studied the whole field of band saw work and after hundreds of band saw users had been consulted to determine the most useful capacity for a medium sized machine, they settled on the 14" x 6" size, meaning that the maximum width of cut between the band saw frame and the blade was 14" and the maximum height of the cut between the table top and the upper blade guide was 6". In 1945, the basic Delta Band Saw was known as Model No.
0 kommentar(er)
